MD-3A METASCAPE WHITE & PACKS
Product Information
Metamark MD3A is a gloss white digital vinyl with the MetaScape adhesive system. Offering a high level of performance for short to medium term indoor, outdoor and general signage, with easy of appliaction and removal of bubbles thanks to the MetaScape system. Can be used on most flat or slightly curved surfaces.
Packs available with matching Metamark MG300 series ovelaminate MG302-Matt or MG305-Gloss
Features:
- 70 micron
- White Gloss
- Calendered PVC
- MetaScape adhesive system
- Permanent clear solvent-based acrylic adhesive
- Layflat kraft paper liner with PE coating
- Up to 3 years durability
More information in the FAQ tab below.
We deliver all over Australia!
Check our FAQ's for lead times.
Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.
Adhesive:
- ‘MetaScape’ permanent clear solventbased acrylic with air channels.
Release Liner Print:
- ‘MetaScape’ print
- Weight 140 gsm nominal
- Structured layflat kraft paper with PE coating
Printing and Handling:
- Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
- Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
- Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
- Do not handle the face film directly and ensure it is free from dust and static.
Overlaminate:
- Finishes Available - MG-302 Matt and MG-305 Gloss
- Face Film: Calendered PVC
- Gauge: 70 micron nominal
- Adhesive Type Permanent clear solvent-based acrylic
- Release Liner Print ‘Metamark Digital Vinyl’ blue print
- Weight 140 gsm nominal
- Type Layflat kraft paper with PE coating
- External weathering: 5 years - (unprinted - European conditions)
Overlaminating:
- Overlamination is recommended to prevent abrasion and to extend colour fastness.
- Allow the inks to cure before overlaminating, this is usually 24-48 hours. (Not applicable to HP Latex prints)
- The matched laminate for MD3A is MetaGuard 300. For all other laminates the user should determine suitability.
Application:
- Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours. (Not applicable to HP Latex prints)
- Apply to flat surfaces or simple curves. Apply unstressed. Not suitable for application over rivets or into deep recesses.
- Suitable for dry application only.
- Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate.
Durability:
- 5 years - (unprinted - European conditions)