MDi-GB METAGLIDE B/O WHITE 1370MM X 50MT
Product Information
Metamark MDiG Blockout features the MetaGlide® next generation air release system offering improved all round handling. With its micro structured air release liner, lift and reapply MetaGlide® graphics with a smooth clean peel that prevents damage to the graphic. MetaGlide® system offers exceptional layflat printability. Prints can stay stored or loosely rolled confidently without tunneling or delamination. Metamark’s 70 micron white face film with its distinctive coating technology produces outstanding print performance on Solvent, Eco Solvent, UV and Latex printers, along with a permanent grey solvent-based acrylic adhesive.
Features:
- 70 micron face film
- Gloss white
- Permanent grey solvent-based acrylic adhesive
- MetaGlide® Air Release System
- Outstanding print performance
- Up to 3yrs outdoor lifespan unprinted
- Matching overlaminate MGi
- Printable with Solvent, Eco Solvent, UV and Latex Printers
More information in the FAQ tab below.
We deliver all over Australia!
Check our FAQ's for lead times.
Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.
Face Film:
- Face Film: Polymeric Calendered PVC
- Gauge: 70 micron nominal
Adhesive:
- MetaGlide® Air Release Permanent Grey Solvent-Based Adhesive
- Print: ‘MetaGlide®’ purple print
- Weight: 140 gsm nominal
- Type: Structured layflat kraft paper with PE coating
Printing and Handling:
- Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
- Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
- Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
- Do not handle the face film directly and ensure it is free from dust and static.
Overlaminating:
- Overlamination is recommended to prevent abrasion and to extend colour fastness.
- Allow the inks to cure before overlaminating, this is usually 24-48 hours.
- The matched laminate for MDiG is MetaGuard MGi. For all other laminates the user should determine suitability.
Application:
- Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours. Suitable for dry application only.
- Apply to flat surfaces or simple curves. Apply unstressed. Not suitable for application over rivets or into deep recesses.
- Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate.
- Refer to www.metamark.co.uk for application guidelines.
Durability:
- External weathering: 5 years - (unprinted - European conditions)