METAMARK MD-3 GLOSS WHITE PACKS

Adhesive Type:

• Permanent clear solvent-based acrylic

Release Liner Print:

• ‘Metamark Digital Vinyl’ blue print 
• Weight 140 gsm nominal 
• Type Layflat kraft paper with PE coating

Printing and Handling:

• Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first. 
• Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
• Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
• Do not handle the face film directly and ensure it is free from dust and static. 

Overlaminate:

• Finishes Available - MG-302 Matt and MG-305 Gloss
  
• Face Film: Calendered PVC 
• Gauge: 70 micron nominal
• Adhesive Type Permanent clear solvent-based acrylic
• Release Liner Print ‘Metamark Digital Vinyl’ blue print 
• Weight 140 gsm nominal 
• Type Layflat kraft paper with PE coating
• External weathering: 5 years - (unprinted - European conditions)

Overlaminating:

• Overlamination is recommended to prevent abrasion and to extend colour fastness.
• Allow the inks to cure before overlaminating, this is usually 24-48 hours. (Not applicable to HP Latex prints)
• The matched laminate for MD3 is MetaGuard 300. For all other laminates the user should determine suitability.

Application:

• Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours. (Not applicable to HP Latex prints)
• Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
• Suitable for wet application. Always apply dry into recesses, or where the print is cut flush, to ensure best adhesion.
• Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate.

Durability:

• 5 years - (unprinted - European conditions)