METAMARK MD-5 B/O WHITE

Adhesive:

• Permanent grey solvent-based acrylic

Release Liner:

• Print ‘Metamark Digital Vinyl’ grey print
• Weight 140 gsm nominal 
• Type Layflat kraft with PE coating

Printing and Handling:

• Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
• Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
• Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
• Do not handle the face film directly and ensure it is free from dust and static.

Overlaminating:

• Overlamination is recommended to prevent abrasion and to extend colour fastness.
• Allow the inks to cure before overlaminating, this is usually 24-48 hours.
• The matched laminate for MD5-B is MetaGuard 700. For all other laminates the user should determine suitability.

Application:

• Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours.
• Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
• Suitable for wet application. Always apply dry into recesses, and where the print is cut flush, to ensure best adhesion.
• Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate

Durability:

• 7 years - (unprinted - European conditions)