METAMARK MD-i-AB METASCAPE B/O GLOSS WHITE
Product Information
Metamark MD-i-A features the ‘MetaScape’ adhesive system, offering ease of application by providing air with an exit route from under the graphic, making for faster, trouble-free application. MD-i-A is ideal for dry apply, medium term applications onto flat or simple curves including vehicle graphics. Suitable for printing with Solvent, Eco Solvent, Latex and UV inks. MG-i is the matching overlaminate.
Also available in Media/Lam Packs
Features:
- 70 micron
- Polymeric calendered film
- Grey ‘MetaScape’ Adhesive
- Up to 3 years outdoor durability
More information in the FAQ tab below.
We deliver all over Australia!
Check our FAQ's for lead times.
Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.
Face Film:
- Face Film: Polymeric Calendered PVC
- Gauge: 70 micron nominal
Adhesive:
- Permanent grey solvent-based acrylic
Release Liner:
- Print: ‘MetaScape’ purple print
- Weight: 140 gsm nominal
- Type: Layflat kraft paper with PE coating
Printing and Handling:
- Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
- Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
- Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
- Do not handle the face film directly and ensure it is free from dust and static.
Overlaminating:
- Overlamination is recommended to prevent abrasion and to extend colour fastness.
- Allow the inks to cure before overlaminating, this is usually 24-48 hours.
- The matched laminate for MD-i-AB is MetaGuard MGi. For all other laminates the user should determine suitability.
Application:
- Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours.
- Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
- Suitable for wet application. Always apply dry into recesses, or where the print is cut flush, to ensure best adhesion.
- Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate
Durability:
- External weathering - 5 years (unprinted - European conditions)
Continue Shopping
