METAMARK MD5 HIGH TACK BLOCKOUT
Product Information
Metamark MD5-HB is a high tack vinyl, that has been developed to apply to 'difficult to stick to' surfaces, including smooth low energy plastics such as PE and PP, and for interior wall applications. (For use on smooth, sealed interior walls) Giving additional assurance of a high bond adhesive with the MD5 series film, the MD5-HB delivers outstanding print performance. Available in Packs with O/lams
Features:
- 70 micron
- White Gloss
- Polymeric Calendered Vinyl
- High tack permanent grey solvent-based acrylic
- 140gsm Layflat PE kraft liner
- External weathering 7 years (Unprinted)
- Fire Rating Class B - BS EN 13501-1:2018
- REACH and RoHS Compliant
- Matching Overlaminates MG702 / 703 / 705
- Compatible with Solvent, Eco Solvent Plus, UV & Latex printers
- Full roll is 50mts
- 1370mm available by the metre or full roll
More information in the FAQ tab below.
Starting at
$680.02
Prices exclude GST.
We deliver all over Australia!
Check our FAQ's for lead times.
Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.
Face Film:
- Face Film Polymeric calendered PVC
- Gauge 70 micron nominal
Adhesive Type:
- High tack permanent grey solvent based acrylic
Release Liner:
- Print: ‘Metamark Digital Vinyl’ grey print
- Weight: 140 gsm nominal
- Type: Layflat kraft with PE coating
Printing and Handling:
- Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
- Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk
- Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
- Do not handle the face film directly and ensure it is free from dust and static.
Application:
- Allow the inks to cure before cutting flush to the print. This is usually 24-48 hours. (Not applicable to Latex prints)
- Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
- Suitable for wet application. Always apply dry into recesses, and where the print is cut flush, to ensure best adhesion.
- The user should determine suitability of substrate.
Overlaminating:
- Overlamination is recommended to prevent abrasion and to extend colour fastness.
- Allow the inks to cure before overlaminating, this is usually 24-48 hours.
- The matched laminate for MD5-H-B is MetaGuard 700. For all other laminates the user should determine suitability.
Durability:
- External weathering - 7 years (unprinted - European conditions)