METAMARK WALLART
Product Information
Metamark ‘WallArt’ is a 150 micron film and offers an ideal solution for printable wall coverings, including retail and leisure, exhibition and home décor applications,enhancing the opportunities available for wall décor. The textured weave finish provides an attractive appearance without lamination, and gives a highly vibrant print image, retaining greater intensity of the colours compared to traditional textile or paper based products.It has a high level of opacity, and makes for no show-through on overlap joins. The self-adhesive 150 micron PVC film with permanent MetaScape air release adhesive allows for clean, easy handling and is printable with Solvent, Eco Solvent, Latex and UV printers.
Please Note: Due to the variability of walls it is vital to assess the suitability, and surface preparation needed. It is suitable for smooth walls.
No liability is given for damage to painted surfaces as the bond between the paint and the wall is out of oanyones control.
Metamark also offer a range of overlaminates with the same textures! Check them out here: Metagaurd decor range
- MD-WA-01 Artisan
- MD-WA-02 Sandtex
- Polymeric Calendered PVC face film
- MetaScape® permanent solvent-based acrylic adhesive with air channels.
- Anti-Scuff, abrasion resistant
- High opacity film for no show-through
- External weathering 7 years (Unprinted)
- Fire Rating C-s1-d0 in accordance with BS EN 13823 (SBI): 2010 and EN 11925-2
- REACH and RoHS Compliant
More information in the FAQ tab below.
We deliver all over Australia!
Check our FAQ's for lead times.
Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.
Finishes Available:
- MD-WA-01 Artisan
- MD-WA-02 Sandtex
Adhesive:
- Type: MetaScape® permanent solvent-based acrylic with air channels
- Perceived tack: High
Release Liner:
- Print: MetaScape print
- Weight: 140 gsm nominal
- Type: Structured Layflat kraft with PE coating
Printing and Handling:
- Always perform a test print first.
- Ensure that the correct profiles and heater settings are used.
- Refer to www.metamark.co.uk.
- Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
- No lamination needed
Application:
- Allow a minimum of 24-48 hours for the solvents to dry off before application of the overlaminate, or to the vehicle, depending on the print and drying conditions this can often be in excess of 48 hours. Retained solvents will reduce adhesion levels.
- Ensure the surface is clean from contamination, dust free, and dry before applying graphics.
- Apply using a dry application method.
- Testing for suitability is recommended prior to applications.
- Edges and overlaps should be applied with heat and a roller.