Can't make up your mind?

You can now select up to 4 products to do a product comparison. Do a comparison now

Go to product comparison

METAMARK MD-I-G METAGLIDE WHITE GLOSS

main product photo

Product Information

Metamark MDiG featuring the MetaGlide® air release system, that improves all round handling. With micro structured air release liner, you can lift and reapply MetaGuide graphics with a smooth clean peel that prevents damage to the graphic. With exceptional layflat printability, prints can stay stored or loosely rolled confidently without tunneling or delamination. 

Features:

  • Gloss white
  • 70 micron face film
  • Outstanding print performance
  • Up to 3yrs outdoor lifespan unprinted
  • Matching overlaminate MGi
  • Printable with Solvent, Eco Solvent, UV and Latex Printers
  • Availabe in packs with matching Overlaminates 

More information in the FAQ tab below.

Starting at $544.77
Prices exclude GST.
Add to Product Comparison Add to Wishlist

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.

You're enquiring:METAMARK MD-I-G METAGLIDE WHITE GLOSS
Please type the letters and numbers below

Face Film:

  • Face Film: Polymeric Calendered PVC
  • Gauge: 70 micron nominal

Adhesive:

  • MetaGlide® Air Release Permanent Solvent-Based Adhesive
Release Liner:
  • Print: ‘MetaGlide®’ purple print 
  • Weight: 140 gsm nominal 
  • Type: Structured layflat kraft paper with PE coating

Printing and Handling:

  • Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first. 
  • Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
  • Do not handle the face film directly and ensure it is free from dust and static. 

Overlaminating:

  • Overlamination is recommended to prevent abrasion and to extend colour fastness.
  • Allow the inks to cure before overlaminating, this is usually 24-48 hours.
  • The matched laminate for MDiG is MetaGuard MGi. For all other laminates the user should determine suitability. 

Application:

  • Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours. Suitable for dry application only. 
  • Apply to flat surfaces or simple curves. Apply unstressed. Not suitable for application over rivets or into deep recesses.
  • Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate. 
  • Refer to www.metamark.co.uk for application guidelines.

Durability:

  • External weathering: 5 years - (unprinted - European conditions)